FREE SHIPPING ON ALL UK ORDERS OVER £30! USE CODE "FREESHIP" AT CHECKOUT

EzyDog Harness Drive Car Harness
EzyDog Harness Drive Car Harness
EzyDog Harness Small Drive Car Harness
EzyDog Harness Drive Car Harness
  • Load image into Gallery viewer, EzyDog Harness Drive Car Harness
  • Load image into Gallery viewer, EzyDog Harness Drive Car Harness
  • Load image into Gallery viewer, EzyDog Harness Small Drive Car Harness
  • Load image into Gallery viewer, EzyDog Harness Drive Car Harness

Drive Car Harness

Regular price
£70.00
Sale price
£70.00
Regular price
Sold out
Unit price
per 
Tax included.

The Drive Car Harness has been designed to safely secure your dog whilst travelling in a vehicle.

Simply feed the seat belt through both webbing handles on the top of the harness, click the buckle into the seat belt of your car and you're ready for the Drive. You only have to fit the harness to your dog once (see 'Size and Fitting’ tab above). From then on, the Harness can be taken on/off very quickly using the Mag-Lok Instant Fit closure system. 

This Dog Travel Harness is also equipped with double stainless steel D-rings to escort your dog to and from the vehicle. 

  • One-time fit
  • Ergonomic, moulded chest-plate
  • Complies with Rule 57 of the highway code

 

Hand wash in mild detergent and air dry in shade. Store in a dry place, out of direct sunlight.

Regularly inspect your harness for any signs of damage and excessive wear including: deformed metal, frayed edges, pulled stitches, sun damage or bite marks. Always replace harness if showing signs of damage.

For best fit measure the girth of your dog. This is the area behind the front legs and around the body. The neck will typically fall into place once the girth is determined. If the measurement is close to the end of the size range, go up to the larger size.

Size Girth (cm) Girth (inches)
S 28 - 64 11 - 25
M 38 - 86 15 - 34
L 49 - 106 19 - 42

 

Refer to the Product Video tab above for the Fitting Guide Video.

 

FITTING INSTRUCTIONS

 

1.UNLACE AND LOOSEN WEBBINGS FROM ALLOY TRI GLIDE. PLACE HARNESS ON DOG

2.ADJUST BOTH FRONT CHEST WEBBINGS TO A FIRM FIT. USE MEASUREMENTS TO BALANCE WEBBING LENGTHS REPEAT ADJUSTMENT TO REAR GIRTH WEBBINGS

3.LOCK ALL FOUR WEBBINGS IN PLACE BY FEEDING BACK THROUGH ALLOY TRIGLIDE

4.FEED WEBBING TAIL UNDER WEBBING KEEPER AND LOCATE KEEPER BACK AGAINST TRIGLIDE. FOLD EXCESS WEBBING AND SECURE IN KEEPER

5.PLACE FITTED HARNESS ON DOG AND POSITION IN CAR. THREAD SEAT BELT THROUGH BOTH HANDLES AND CLICK INTO BUCKLE. REMOVE SLACK FROM SEAT BELT

IMPORTANT: DO NOT OVER-TIGHTEN STRAPS! WHEN FITTED CORRECTLY, HARNESS SHOULD BE SNUG, BUT TWO FINGERS SHOULD EASILY RUN BETWEEN STRAPS & DOG.

Net Orders Checkout

Item Price Qty Total
Subtotal £0.00
Shipping
Total

Shipping Address

Shipping Methods