One-time fit. Full-time safety.

The Drive Car Harness by EzyDog is purpose-built to safely secure your dog during vehicle travel, giving you peace of mind on every journey. Designed for both safety and convenience, it complies with Rule 57 of the UK Highway Codeand helps prevent driver distraction while offering a secure, comfortable fit for your dog.

Fitting the harness is a one-time task — once adjusted, the Mag-Lok™ Instant Fit closure system allows for quick and easy on/off application. The ergonomic, moulded chest plate offers comfort and stability, while dual stainless steel D-rings allow you to attach a lead for walking to and from the vehicle.

Key Features

Complies with Highway Code Rule 57 for dog travel safety
One-Time Fit Design – no need to readjust each time
Mag-Lok™ Instant Fit System for quick and easy use
Ergonomic Moulded Chest Plate for comfort and support
Double Stainless Steel D-Rings for lead attachment
Secure Seatbelt Integration: Thread your car seatbelt through both webbing handles

Drive safe. Drive smart. Travel protected.

Hand wash in mild detergent and air dry in shade. Store in a dry place, out of direct sunlight.

Regularly inspect your harness for any signs of damage and excessive wear including: deformed metal, frayed edges, pulled stitches, sun damage or bite marks. Always replace harness if showing signs of damage.

For best fit measure the girth of your dog. This is the area behind the front legs and around the body. The neck will typically fall into place once the girth is determined. If the measurement is close to the end of the size range, go up to the larger size.

Size	Girth (cm)	Girth (inches)
S	28 - 64	11 - 25
M	38 - 86	15 - 34
L	49 - 106	19 - 42

Refer to the Product Video tab above for the Fitting Guide Video.

FITTING INSTRUCTIONS

1.UNLACE AND LOOSEN WEBBINGS FROM ALLOY TRI GLIDE. PLACE HARNESS ON DOG

2.ADJUST BOTH FRONT CHEST WEBBINGS TO A FIRM FIT. USE MEASUREMENTS TO BALANCE WEBBING LENGTHS REPEAT ADJUSTMENT TO REAR GIRTH WEBBINGS

3.LOCK ALL FOUR WEBBINGS IN PLACE BY FEEDING BACK THROUGH ALLOY TRIGLIDE

4.FEED WEBBING TAIL UNDER WEBBING KEEPER AND LOCATE KEEPER BACK AGAINST TRIGLIDE. FOLD EXCESS WEBBING AND SECURE IN KEEPER

5.PLACE FITTED HARNESS ON DOG AND POSITION IN CAR. THREAD SEAT BELT THROUGH BOTH HANDLES AND CLICK INTO BUCKLE. REMOVE SLACK FROM SEAT BELT

IMPORTANT: DO NOT OVER-TIGHTEN STRAPS! WHEN FITTED CORRECTLY, HARNESS SHOULD BE SNUG, BUT TWO FINGERS SHOULD EASILY RUN BETWEEN STRAPS & DOG.

Car Harnesses